|
Tips:5¢ Advice:Free
Join Date: Aug-2001
Location: Silicon Valley
Country: USA
Posts: 9,742
|
Now a nail is dropped through a small pilot hole drilled in the exact center of the table. This allows the turntable to be lined up perfectly with the base.
A second round may optionally be added and screwed or glued to the first. This provides some extra clearance above the tabletop if you are working on larger trees that overhang the turntable. This step is optional.
See that small access hole that is drilled at about 10 o'clock on the table? That hole provides access to put the remaining four screws in place. You do that from the top, one at a time by turning the table until you can see the hole in the mechanism,
Dropping in a screw, and tightening.
__________________
bonsaiTALK: Over 100,005.36 Megabytes Served this Month!
|